Full Description

1.1 This test method covers the quantitative determination of water down to 20 ppm in plastics using a relative humidity sensor. 1.2 Values stated in SI units are to be regarded as standard. 1.3 Specimens tested in this test method can reach or exceed 250C, use caution when handling them after testing has completed. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Note 1: There is no known ISO equivalent to this standard. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Product Details

Published:

05/01/2024

Number of Pages:

4

File Size:

1 file , 260 KB

Redline File Size:

2 files , 340 KB

Note:

This product is restricted and cannot be purchased in the following countries Russia, Ukraine, Belarus